Workshop on “PCB Designing and Fabrication”

PHCET > Electrical Seminars & Workshops > Workshop on “PCB Designing and Fabrication”

Department of Electrical Engineering has organized a Two Days Workshop on “PCB Design and Fabrication” under IEI student Chapter on 26th and 28th March, 2022.

Speaker and Coordinator
26th and 28th March, 2022
Electrical Workshop Lab
11:00 a.m. to 4:00 p.m.
Prof. Supriya Shigwan and Prof. Ronita Pawn

PCB Designing is one of the most emerging fields in Electronics in today’s era. For the students of Electrical this is a good field to start their career. PCB designers are key persons in research and development (R&D), electronics production units as well as in the PCB industry. The workshop was aimed to provide knowledge about simulation tools to test electronics & electrical circuits in software environments, PCB design software named DIPTRACE & to make physical PCB at home so that any student can make a project on his own.

Schedule: Day 1 – Software Session

2:00 p.m. to 2.10 p.m.
3.40 p.m. to 3.50 p.m.
3.50 p.m. to 4:00 p.m.
Introductory Talk
Hands on Software Session – Diptrace
Query Session

Schedule: Day 2 – Hardware session

11:00 a.m. to 11:20 a.m.
11:20 a.m. to 12:00 p.m.
12:00 p.m. to 1.00 p.m.
1.30 p.m. to 3.50 p.m.
3.50 p.m. to 4:00 p.m.
Introduction and Component Distribution
Ironing and Etching
Drilling and Component Placing
PCB Lab Visit
Query Session and Vote of Thanks

Following content are covered in workshop:

  • Schematic Design
  • Component Footprint Design
  • Integrated Library Design
  • PCB Design & Routing
  • Etching of PCB
  • Soldering of Components on PCB

Process of Printing the Inner layers and Removing the Unwanted Copper

Software Session

Key information about PCB designing by Prof. Ronita Pawn

With Faculties

Explaining PCB designing Steps by Prof. Supriya Shigwan

Etching Process


With Students

Explaining Design Process of PCB in Industry by Mr. Shubham

PCB Lab Visit

Total 68 students and 7 faculties have participated in the workshop. All the students responded that they have learned and had hands-on experience in designing a PCB. They were very excited about participating in this workshop and requested for more workshops in a similar way so that they can simultaneously gain practical knowledge.